Category Archives: Chassis

Ognibene sprockets

The first Ognibene (7164-16) 16 tooth front sprocket was fitted last April, since then its done over 18,000 miles and I’m happy to say, still has some life left in it. In comparison to the excellent Renthal sprockets that I’d … Continue reading

Posted in Chassis, Engine | Tagged , , , , , , , , , , , , , , , | Leave a comment

More bunged up …… or spoke too soon!

I’ve been carrying six spare spokes around in the front wheel spindle for years ….. however the whole thing was a bit of a mash-up and not worthy of a post on here unless I desperately wanted some serious ridicule. … Continue reading

Posted in Chassis | Tagged , , , , , , , , , , , , , , , , | 2 Comments

Feeling a little bunged up

The Capo now has 3D printed bungs in the swing arm pivot and the ends of the crash-bar mounts. They’re held in by 43-39-2, 14-10-2 and BS011 ‘O’-rings. And yes, the BS011 rings are the very same as those used … Continue reading

Posted in Chassis | Tagged , , , , , , , , , , , , , , , , | Comments Off on Feeling a little bunged up

New closure panel and heatshield

I finally got around to finishing off the new closure panel (AP8168916) and seat/tank heatshield (AP8117201 – now unavailable) using the 2mm rubber sheet I bought a few months ago. A single 500mm x 500mm piece is enough to make … Continue reading

Posted in Chassis | Tagged , , , , , , , , , , | Comments Off on New closure panel and heatshield

She’s let me down!

We called into a fuel station about 20 miles from home just as a thunderstorm was rolling toward us over the Gran Sasso mountains. It rumbled away as the sky drew ever darker while I filled up a 5l gas … Continue reading

Posted in Chassis | Tagged , , , , , , , , , | Comments Off on She’s let me down!