Superseal | Moto-Abruzzo

I finally got around to changing out the open-to-air 4-way connector that feeds the fuel pump and fuel level sensor. In went a nice 4-way Superseal (14A rated) with the connectors crimped, soldered and given a light coat of dielectric grease before sliding home into the waterproof housing.

Hopefully no more erratic fuel level due to oxidation on the pins! While I was at it I pulled the spare fuel pump harness (AP8124664) out of its bag and changed its connector as well. I’d look mighty foolish if I’d pulled that out of my spares kit at the roadside and the connectors didn’t match!

While under the hood, I noticed that the outer coat of the fuel return line (marine-grade ISO 7840 A1) is showing signs of deterioration and kinking near the swaged end at the fuel tank. I’d noticed it back in September, but unfortunately it appears to be a little worse now. Time then to order a new cLCD 170-04 1/4″ barbed quick release connector from Tom Parker (UK) along with suitable Oetiker clamps – I’ll only use clamps that need to be crimped, never ones with screws that can work loose. I’ve no problem doing the return hoses myself, but when it comes to the high pressure side, I leave it to the professionals. Last time that was MF Hydraulics in Oxford and I’ll be happy to use them again come the day.

The marine hose has lasted well (9 years) and that’s to be expected given that hose for marine applications has to meet very strict guidelines, however I think hose rated at SAEJ30R9 with its improved impermeability and tolerance to Ethanol is probably better suited on the Capo nowadays. Either way I wouldn’t lose any sleep over it! The high pressure line and main return line are holding up just fine with no sign of wear or deterioration.

OK I’ll come clean. I’m a bit of a closet bodger – there I’ve said it. Let’s be fair though, the art of bodging is a skill in itself. A well carried out bodge, with novel and outlandish use of alternative materials to affect a successful repair or upgrade is a beauty to behold. But then again a bad bodge will bite you on the arse quicker than a rabid badger having a rather bad-badger day.

So what did I bodge? Well the LED’s in the Capo’s binnacle might be nice and bright but the wiring behind them certainly wasn’t! Of course a lifetime of working with electric/electronics gives one a certain feel for the bodge to be enacted – why use a decent connector when twisting the wires together and slapping on a bit of insulating tape works just as well …… right?

Aprilia Caponord ETV1000 Rally-Raid AS7, Sparkbright and dashboard autodimming LED's

To be fair it was a temporary solution until I’d got hold of some connectors, except I kept forgetting and one thing led to another … And in the blink of an eye, a couple of years had gone by! Last week however, good old Motrag came to the rescue (again!) with a box full of 2 and 3 way Superseal connectors. I really do like these – 14A rated and waterproof (IP67) compared to the Molex items dotted around the Capo that are 5A and most certainly open to the elements. The only downside is that they are more bulky than the Molex so you can’t cram as many into a tight space!

Of course a cunning and artful bodger could fit these without the correct tool to crimp the connectors, but I yielded to common sense – besides Manuel had put a nifty set of crimping pliers in the box as well! Now all the panels are removable with a mere flick of a locking-tab, no longer do I wish for an extra appendage to assist in separating wires/tape while juggling with the panel. Sheer bliss! Here is a copy of the Superseal installation manual.

Tag: Superseal

While the tank was off ……

The Artful Bodger