Tag Archives: print

Keeping the postman busy

After January’s awful weather – snow, rain, sub-zero temps, earthquakes & landslides, it’s been a very nice balmy February! So much so, that the Capo has squirreled a good few miles under its belt – the last 300 of them … Continue reading

Posted in Engine | Tagged , , , , , , , , , , , , , , , | Comments Off on Keeping the postman busy

Take a deep breath ……..

With plans a-foot to assemble a big-cc motor for the Capo, it was time to cast an inquisitive eye over the airbox snorkel, that ugly rubber protrusion at the front of the airbox, sucking in hot air from on top … Continue reading

Posted in Engine | Tagged , , , , , , , , , , , , , , , | 2 Comments

A little unhinged

The day before the awful January weather hit, I managed to get a nice afternoon ride-out on the Capo. Stopping part way along for a coffee break, I paused for a moment to put helmet and gloves in the top-box … Continue reading

Posted in Luggage | Tagged , , , , , , , , , , , , , , | Comments Off on A little unhinged

More bunged up …… or spoke too soon!

I’ve been carrying six spare spokes around in the front wheel spindle for years ….. however the whole thing was a bit of a mash-up and not worthy of a post on here unless I desperately wanted some serious ridicule. … Continue reading

Posted in Chassis | Tagged , , , , , , , , , , , , , , , , | 2 Comments

Feeling a little bunged up

The Capo now has 3D printed bungs in the swing arm pivot and the ends of the crash-bar mounts. They’re held in by 43-39-2, 14-10-2 and BS011 ‘O’-rings. And yes, the BS011 rings are the very same as those used … Continue reading

Posted in Chassis | Tagged , , , , , , , , , , , , , , , , | Comments Off on Feeling a little bunged up