Tag Archives: panel

Take a deep breath ……..

With plans a-foot to assemble a big-cc motor for the Capo, it was time to cast an inquisitive eye over the airbox snorkel, that ugly rubber protrusion at the front of the airbox, sucking in hot air from on top … Continue reading

Posted in Engine | Tagged , , , , , , , , , , , , , , , | 2 Comments

New closure panel and heatshield

I finally got around to finishing off the new closure panel (AP8168916) and seat/tank heatshield (AP8117201 – now unavailable) using the 2mm rubber sheet I bought a few months ago. A single 500mm x 500mm piece is enough to make … Continue reading

Posted in Chassis | Tagged , , , , , , , , , , | Comments Off on New closure panel and heatshield

Fuse box panel

On the Mark 1 Capo there’s a screw-on cover, on the Mark 2 a panel held on by 4 screws but on the Raid it’s just waving in the wind …. staring at you with those half-inch high letters screaming … Continue reading

Posted in Chassis, Dashboard | Tagged , , , , , , , , | 2 Comments