Tag Archives: ‘o’ ring

Feeling a little bunged up

The Capo now has 3D printed bungs in the swing arm pivot and the ends of the crash-bar mounts. They’re held in by 43-39-2, 14-10-2 and BS011 ‘O’-rings. And yes, the BS011 rings are the very same as those used … Continue reading

Posted in Chassis | Tagged , , , , , , , , , , , , , , , , | Comments Off on Feeling a little bunged up

A pivotal moment

Sometime last year I decided that 2015 was going to be the year that a whole bunch of parts were going to get cleaned up and recoated – engine/sump protection bars (especially the mounting brackets), headlamp guard and passenger foot … Continue reading

Posted in Chassis | Tagged , , , , , , , , , , , , | Comments Off on A pivotal moment