Tag Archives: 3D

Keeping the postman busy

After January’s awful weather – snow, rain, sub-zero temps, earthquakes & landslides, it’s been a very nice balmy February! So much so, that the Capo has squirreled a good few miles under its belt – the last 300 of them … Continue reading

Posted in Engine | Tagged , , , , , , , , , , , , , , , | Comments Off on Keeping the postman busy

Take a deep breath ……..

With plans a-foot to assemble a big-cc motor for the Capo, it was time to cast an inquisitive eye over the airbox snorkel, that ugly rubber protrusion at the front of the airbox, sucking in hot air from on top … Continue reading

Posted in Engine | Tagged , , , , , , , , , , , , , , , | 2 Comments

Airbox crankcase vent – Mk2

With the velocity stacks and snorkel measured up and squirreled away in CAD, it was time to rebuild the airbox …… except billy-butter-fingers here, went and knocked the airbox base off a chair onto the floor – not far – … Continue reading

Posted in Engine | Tagged , , , , , , , , , , , | Comments Off on Airbox crankcase vent – Mk2

Hybrid velocity stacks

If all goes to plan, later this year the second Rally-Raid that’s currently being rebuilt, will finally get a motor installed. The plan is to use a big-bore motor …. an 1,103cc in place of the standard 998cc. The compression … Continue reading

Posted in Engine | Tagged , , , , , , , , , , , , , , , , , | Comments Off on Hybrid velocity stacks

A little unhinged

The day before the awful January weather hit, I managed to get a nice afternoon ride-out on the Capo. Stopping part way along for a coffee break, I paused for a moment to put helmet and gloves in the top-box … Continue reading

Posted in Luggage | Tagged , , , , , , , , , , , , , , | Comments Off on A little unhinged